Delete microsoft network adapter multiplexor driver

 · Actually, Microsoft Network Adapter Multiplexor Protocol is a kernel device driver that is used for Network Interface Card (NIC) bonding. What does this mean? First, you should understand what NIC teaming is. NIC teaming refers to the process of teaming or linking two or more network cards in a group to form one physical device for the purpose Estimated Reading Time: 3 mins.  · The Microsoft Network Adapter Multiplexor Protocol is listed in the ‘items this connection uses’ list for the Wi-Fi properties. This alternative is disabled for many people by default, and it usually gets them confused if they need to disable or enable it and, by doing that, how it can affect their connection or bandwidth.  · Update: Rebooted the server this morning after removing reg keys for some old virtual NIC's unfortunately it didn't remove these. Also tried to change the MAC address on "Microsoft Network Adapter Multiplexor Driver" to stop the conflict, yet .

You will probably be left with at least one “Microsoft Network Adapter Multiplexor Driver #n” that you are not able to uninstall. Uninstall ALL broadcom drivers/software and reboot. Open device manager again, and get the guid of the stubborn multiplexor adapters: Go to the HKLM\System\CurrentControlSet\Services\NdislmPlatform\Parameters\Teams registry key: Delete the entire team key that corresponds to the key you found above, that is the key labeled {GUID} under Teams. Resolution. Microsoft doesn't support using this GUI or netcfg to uninstall protocols or built-in drivers. Instead, you can unbind the driver from Network Adapters either by using this GUI or the PowerShell cmdlet Disable-NetAdapterBinding. This is effectively the same as uninstalling the driver. The proper way to reconfigure the host was to remove the VM Network adapter with the command Get-VMNetworkAdapter -ManagementOS | Remove-VMNetworkAdapter Then remove the vSwitch Get-vmswitch -name "Prod-Management-Hosts_Logical-Switch | remove-vmswitch.

23 ມ.ກ. Now if you check the box for this option, a quick dialog box will appear with a message “Your current selection will also disable the following. 8 ມ.ສ. In the Properties, you should see the Description set to “Microsoft Network Adapter Multiplexor Driver.” In the VLAN membership. I would make sure your NIc drivers are up to date, NIC firmware. team members on Team Nic Microsoft Network Adapter Multiplexor Driver.